Autotech USA Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.
Search
 
 

Display results as :
 


Rechercher Advanced Search

Latest topics
» Video of BMW Disa Valve installation
by Admin Fri Jul 19, 2013 5:45 pm

» Mercedes shifter selector repair Guide and Video
by 8thvision Tue Nov 13, 2012 2:11 pm

» 98-01 Toyota Corolla Improved Winshield Washer bottle
by 8thvision Tue Nov 13, 2012 1:49 pm

» 2001 Mercedes Benz W220 Strut
by Admin Mon Nov 12, 2012 6:51 pm

» BMW Disa Valve Installation Video
by Admin Thu Nov 08, 2012 4:58 pm

» BMW M42 and M44 Engines. Disa Valve.
by 8thvision Thu Nov 08, 2012 1:17 pm

» Benz E320 Headlight Wire broken
by kimchi Wed Oct 17, 2012 6:34 pm

» Rides & Styling
by 8thvision Mon Mar 12, 2012 1:06 pm

» Marlon Oakley Graphic Design
by 8thvision Thu Mar 08, 2012 2:28 pm

» Guest Book
by Guest Mon Feb 13, 2012 1:08 pm

March 2024
MonTueWedThuFriSatSun
    123
45678910
11121314151617
18192021222324
25262728293031

Calendar Calendar


Crank Position Sensor (CKP) (Tech Tip)

Go down

 Crank Position Sensor (CKP) (Tech Tip) Empty Crank Position Sensor (CKP) (Tech Tip)

Post  Admin Tue Jul 26, 2011 3:25 pm

Crank Position Sensor (CKP) to indicate when of cylinders reaches TDC (top dead center). It consists of a pulse ring on the crank shaft and a probe with a permanent magnet and a coil wire at its tip. As the crankshaft turns the sudden change in the magnetic flux causes a voltage signal to the produced in the coil wound around the magnet. The CKP provides a reference point for the ECM to create the sparks, timing advance, injector pulses. Cam Position Sensor is relayed through ECM and is used to identify which cylinder is approaching TDC and which ignition coil should be fired, which fuel injector should be injected fuel.

Symptom of Crank Position Sensor Fail: Engine crank but no start, no spark or no injector pulse.

 Crank Position Sensor (CKP) (Tech Tip) Ase-small-tip2

Scan tools provide the best noninvasive method for diagnosing a cranking no start condition. Scan for any crank sensor related code is stored in ECM such P0335, P0336 or more. Second watch the scanner data displays any Engine RPM or speed is displayed during cranking, if it shows RPM signal usually CKP is producing a valid signal is working. If No RPM signal most likely the crank sensor is bad or control circuit failure. Another way connect a voltmeter to beside ignition coil circuit if the voltage pulls down from (positive) B+ during cranking, the CKP is triggering the ignition module or ECM, If the CKP is not triggering spark, possible the caused is Crank Position Sensor, Ignition Control Module, or ECM circuit.
 Crank Position Sensor (CKP) (Tech Tip) FuelDeliverySystemOverViewwatermark
Admin
Admin
Admin

Posts : 24
Join date : 2011-07-14

https://onlinewholesaleparts.board-directory.net

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum